How to Replace the Salt Cell of a Salt Pool Chlorine Generator

A salt pool chlorine generator is an essential component of any saltwater pool system. It works by converting salt into chlorine, which helps to keep your pool clean and clear. However, over time, the salt cell of your chlorine generator may become worn out or damaged, which can lead to reduced performance and even failure of the entire system. In this article, we will guide you through the step-by-step process of replacing the salt cell of your salt pool chlorine generator.

Step 1: Turn off the Power

Before you begin replacing the salt cell, you must first turn off the power to the chlorine generator. This is essential for your safety and to prevent damage to the system. Locate the power source for your chlorine generator and turn it off. You can usually find the power switch near the control panel of your pool system.

Step 2: Remove the Old Salt Cell

Once the power is off, you can begin removing the old salt cell. Start by removing the cell housing cover. This is usually done by unscrewing the cover with a wrench or pliers. Once the cover is removed, you can then remove the old salt cell from the housing. Carefully disconnect the wiring from the cell and remove it.

Step 3: Clean the Housing

With the old salt cell removed, you should take the time to clean the housing. Use a soft brush or cloth to remove any debris or buildup that may have accumulated in the housing. This will help to ensure that the new salt cell fits properly and functions correctly.

Step 4: Install the New Salt Cell

With the housing clean, you can now install the new salt cell. Connect the wiring to the new cell and carefully place it into the housing. Make sure that the cell is properly aligned and seated in the housing. Replace the housing cover and tighten it securely with a wrench or pliers.

Step 5: Turn on the Power

With the new salt cell installed, you can now turn on the power to the chlorine generator. Check the control panel to ensure that the system is functioning properly. If everything is working correctly, you should see the chlorine level in your pool begin to rise.

Step 6: Test the Water

After replacing the salt cell, it is important to test the water in your pool to ensure that the chlorine levels are correct. Use a test kit to check the pH and chlorine levels in your pool. Adjust the levels as necessary to ensure that your pool is safe and clean.

In conclusion, replacing the salt cell of your salt pool chlorine generator is a relatively simple process that can be done with a few basic tools and some careful attention to detail. By following these steps, you can keep your pool system functioning properly and enjoy a clean and clear pool all season long.